Vulcan-Hart EV12 Series, Руководство по обслуживанию

Страница: 9 / 33

Fig. 11
3. Fully open door to check operation. If bottom
edge of door rubs the front edge of cavity bottom,
then the swivel hinge is not engaged as
described.
A. To seat the swivel hinge, open door
approximately 30° and pull in the same
direction on the door handle. The hinge
should drop into place.
4. Open door and check operation. If okay, remove
bolts and close door. If not okay, remove door
and repeat installation procedure.
5. Reinstall oven control panel.
6. Raise kick panel.
OVEN HEATING ELEMENTS
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
Top Element
NOTE:
If the rear of range is accessible, remove rear
flue panel to access the top heating element terminals
and disconnect lead wires. Otherwise, access is
available through the oven cavity as outlined in
procedure.
1. Remove oven racks.
2. Loosen element mounting brackets (1, Fig. 12).
3. Remove element mounting screws (2, Fig. 12).
Fig. 12
4. Remove element from brackets.
NOTE: Some brackets may need to be removed if
turning them will not completely free the element.
5. If removing element through oven cavity,
disconnect lead wires from heating element
terminals.
6. Remove element from oven cavity.
7. Reverse procedure to install.
NOTE: Do not force element into holding brackets.
8. Check range for proper operation.
Bottom Element
NOTE:
The bottom heating element terminals can
only be accessed from the rear of the range.
1. Remove the rear flue panel (1, Fig. 13).
2. Remove element cover (2, Fig. 13).
Fig. 13
3. Disconnect lead wires from element terminals (1,
Fig. 14).
EV Series Electric Ranges - REMOVAL AND REPLACEMENT OF PARTS
Page 9 of 33 F45586 (0716)