Vulcan-Hart EV12 Series, Руководство по обслуживанию

Страница: 12 / 33

4. Remove mounting nuts (3, Fig. 21) securing
griddle element cover to griddle plate.
5. Remove griddle element cover from griddle
plate.
6. Remove mounting nuts (1, Fig. 22) securing the
griddle element clamp (2, Fig. 22).
Fig. 22
7. Remove griddle element clamp (2, Fig. 22) from
the element and griddle plate.
8. Remove griddle element from griddle plate.
9. Reverse procedure to install.
A. Position the element clamp with the
downward bend along the sides of the
clamp toward the griddle plate.
B. Torque the griddle element clamp mounting
nuts to 30 to 35 inch-pounds.
NOTE: A torque wrench is the preferred method for
tightening the griddle element clamp mounting nuts.
However, if a torque wrench is not available, tighten
all griddle element clamp mounting nuts finger tight,
then 1/2 additional turn with a wrench.
10. Check range for proper operation.
OVEN THERMOSTAT
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove thermostat knob.
2. Remove thermostat mounting screws.
Fig. 23
3. Remove OVEN CONTROL PANEL.
4. Disconnect lead wires from thermostat noting
their locations.
Fig. 24
5. Remove thermostat bulb from the oven cavity
mounting clips.
A. Pull capillary tube and thermostat bulb
through the opening in sidewall of the oven
cavity.
EV Series Electric Ranges - REMOVAL AND REPLACEMENT OF PARTS
F45586 (0716) Page 12 of 33