Vulcan-Hart 176-6799, Инструкция по эксплуатации

Страница: 5 / 51

Service
Check for damaged parts . Make frequent
inspections for the correct function of components
and safety mechanism.
Replacement parts . When servicing, use
only identical replacement parts and fasteners
recommended by us.
Service and repairs
should be made by qualified
repair technicians at an authorized repair centre.
Improperly repaired tools could cause serious
shock or injury.
Employers must enforce compliance with the
safety warnings and all other instructions in this
manual. Keep it available for use by everyone
assigned to use this equipment.
Safety precautions for compressor components
Air only: use this compressor for compressing air
only. Do not compress other gases.
Tank safety valve:
this valve prevents damage to
the air receiver if a malfunction in the compressor
pump occurs. It is factory pre-set at a limit
specific to your particular model and adjustment.
Do not tamper with it. This will automatically
void your warranty.
Pressure switch: the air pressure switch is factory
pre-set for optimum performance. Do not bypass
or remove this switch. Serious damage to
equipment or personal injury could result from
too high an air pressure.
Motor and compressor pump:
air compressors
get hot during operation. Do not touch the
motor, discharge tubing, or compressor while
it is running. The compressor turns itself on
automatically while the power is connected.
Air tanks:
over-pressurizing the air receivers,
piping or tanks could cause it to explode or burst.
To protect from over-pressurizing, the compressor
is equipped with a factory preset safety valve. Do
not
remove, make adjustments to or substitutions
for this valve. Perform a test of the valve from
time to time: pull the ring on the valve to make
sure that it operates freely. If the valve does not
operate freely, replace it before further use. Never
weld to, drill into, or change the air receivers in
any way.
Tampering: if any of the components above are
found to have been changed or tampered with, the
warranty will be made void. When servicing, we
recommend using only identical replacement parts
and any replacement parts used must have the
same specification as the original equipment.
The warnings, cautions, and instructions detailed in this manual cannot
cover all possible conditions and situations that occur. It must be understood
by the operator that COMMON SENSE AND CAUTION ARE FACTORS
that cannot be built into this product, but MUST BE SUPPLIED BY THE
OPERATOR.
WARNING
!