Vulcan-Hart 176-6799, Инструкция по эксплуатации

Страница: 11 / 51

11
Removing the Portable Air Tank:
1. Move the Compressor on/off switch ( E, fig.1 & 7 ) to
the off (down) position.
2. Lift the Fold-out rolling transport handle up ( I, fig.1 &
2
) and away from the portable air tank.
3. Close the Input shut-off valve for portable tank ( D,
fig.1 & 7 ) by turning it so the arm points across the
direction of the airflow.
4. Disconnect the hose from the quick connect coupler
(
J,fig.1 & 8
).
5. Loosen the Rubber hold-down straps for portable
tank (H, fig.1 & 2) to release the air tank.
The tank has now been properly disconnected from the
air compressor unit. You can now move the tank
freely.
Installing the Air Tank:
1. Move the Compressor on/off switch (
E, fig.1 & 7
) to
the off (down) position.
2. Place the portable air tank in the appropriate
position, resting on the two Portable tank cradle
brackets ( U, fig.2 ) .
3. Fix the air tank to the compressor unit using the Rubber hold-down straps for portable
tank (H, fig.1 & 2).
4. Reconnect the hose with the quick connect coupler ( J, fig.1 & 8 ).
5. Open the Input shut-off valve for portable tank (
D, fig.1 & 7
) by turning it so the arm points
in the direction of the airflow.
The portable air tank has been properly installed and connected to the air compressor unit.
Your air compressor is now ready for use.
OPERATION
1. Be sure the On/Off switch ( E, fig.1 & 7 ) is swung down & in the Off position.
2. Close (turn the knurled knob in, clockwise) the air tank Moisture release
petcock (Z, fig.6 ).
3. Plug in the power cord.
4. Pull up on the On/Off switch to turn the unit on.
5. Adjust the Regulator (
R, fig.1 & 2 ) so that the needle on the Regulated output pressure
gauge ( O, fig.1 & 2 ) is set to the working pressure of the air tool you plan to use.
6. Connect the air tool to an air hose.
7. Connect the air hose to the compressor by inserting its quick-connector plug into one of
the two quick-connect air couplers ( Q, fig.1 & 2 ) on the compressor panel. Be sure the
connectors are properly connected.