10
CLEARING A JAMMED FASTENER
CAUTION
!
Disconnect the tool from the air supply.
1. Open latch
2. Rotate lower magazine
3. Remove the nails from the magzine.
4. Use a slender; soft steel rod to drive the drive blade to its uppermost position.
5. Use a pair of needle nose pliers to remove the jammed fastener.
FASTENER DEPTH
Driving depth can be adjusted by rotating the depth adjustment knob (
B, fig.1
).
=
Test fire a fastener into a scrap work piece and check
depth.
=
If the nail is driven too deep, rotate the knob (
B, fig.7
)
clockwise (when tool is upside-down) to move the
safety bracket downward.
=
If a greater depth is desired, rotate the knob counter
clockwise to adjust the safety bracket upward.
=
Test fire another fastener in a scrap work piece and
check the depth.
=
REPEAT AS NECESSARY UNTIL DESIRED DEPTH
IS ACHIEVED
. The amount of air pressure required will
vary depending on the setting.
=
Determine the lowest setting that will consistently
perform the job at hand. Air pressure in excess of that
required can cause premature wear and/or damage to
the tool.
CAUTION
!
=
Disconnect tool from air supply before loading fasteners, performing
maintenance, clearing a jammed fastener, leaving working area, moving tool to
another location or handing the tool to another person.
=
Clean and inspect tool daily. Carefully check for proper operation of trigger and
safety mechanism.
=
Do not use the tool unless both the trigger and the safety mechanism are
functional.
=
Do not use the tool if its leaking air or needs any other repair.
Содержание 019-4274
Страница 17: ...17 SCHEMATIC DRAWING...
