Vtronix
5
Testing Heating / Cooling Equipment. (OP:01)
While in the installer setup, slide the mode switch to
heat to operate the heating equipment or cool to
operate the cooling equipment. The display will show
either 00 or 01 on the lower right area and either heat
or cool as selected by the mode switch.
a. If the equipment is off, press
Ñ
key to turn it on
(if not, check the wiring or the equipment).
b. Press
Ñ
key again to turn off.
Example display showing
Heat equipment is off.
Example display showing
Heat equipment is on.
Example display showing
Heat equipment is off.
Example display showing
Heat equipment is on.
Now follow the following steps to change each of the
settings. Each time you press
D
key, you will advance
to the next operating parameter. To go back you must
re-enter the installer set up as described above.
INSTALLER SETUP
The following instructions provide information to
test the heating / cooling equipment and to change
operating parameters from the factory settings.
Enter Installer Setup
a. Use
D
or
Ñ
key to set the temperature set point
to 52
°
F (or 11
°
C).
Fig. 10. Secure the front cover.
Secure the thermostat by tightening the screw
provided to protect the thermostat from unwanted
access.
OR
b. Press
D
and
Ñ
key
simultaneously to enter installer
setup.
Setting
°
C /
°
F Indication. (OP:02)
While in the installer setup,
a.
Press
D
key, the display will
show
°
F/
°
C indication.
b.
Press
Ñ
key to change
°
F or
°
C
indication.
NOTE: Factory setting
is
°
F indication.
