17
Figure 1
Figure 2
U S I N G T H E WA L L M O U N T
ADAPTOR
1. Choose a spot near an electrical
outlet and a telephone jack.
You phone requires a modular
telephone jack and a standard
electrical outlet (120v AC). The
power cord is six feet long; make
sure there is an electrical outlet
within reach of the Base Unit. The
outlet should not be controlled by
a wall switch. If the switch is ever
turned off, the phone will not
operate.
2. Position the wall mount bracket
on the base.
Line up the tabs on the wall mount
adaptor with the holes on the
bottom of the base (Figure 1).
Snap the wall mount bracket firmly
in place.
3. Mount the base on the wall.
Position the base so the mounting
studs will fit into the holes on the
bottom of the base. Position the
power cord to extend down the wall
the phone is to be mounted on.
Slide the base down on the
mounting studs until it locks into
place.
4. Connect the telephone line cord.
The telephone line cord has a
snap-in plug at each end. Insert
one of the plugs into the jack on the
bottom of the base. Insert the other
end of the plug into the wall jack.
5. Plug the AC adaptor into an
electrical outlet and the DC
connedor on the back of the
Base Unit.
PULSE
TO
N
E
WALL MOUNTING
PAGE
HS IN-USE
CHARGING
SPARE BATT
4
5
6
7
8
9
10
DIGITAL
CORDLESS
900MHz
1901MANUAL
1/28/99, 3:29 PM
17
