www.vtechphones.com
56
Important safety instructions
FCC Part 5
This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 5 of the Federal Communications Commission (FCC) rules These requirements
are intended to provide reasonable protection against harmful interference in a residential installation This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications However, there is no guarantee that interference will not occur in a particular installation If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
* Reorient or relocate the receiving antenna
* Increase the separation between the equipment and receiver
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
* Consult the dealer or an experienced radio/TV technician for help
6 Slots and openings in the back or bottom of the telephone base and handset are provided for ventilation To protect them from overheating, these openings must not be blocked by placing
the product on a soft surface such as a bed, sofa or rug This product should never be placed near or over a radiator or heat register This product should not be placed in any area where proper
ventilation is not provided
7 This product should be operated only from the type of power source indicated on the marking label If you are not sure of the type of power supply in your home, consult your dealer or local power
company
8 Do not allow anything to rest on the power cord Do not install this product where the cord may have anyone walking on it
9. Never push objects of any kind into this product through slots in the telephone base or handset as they may touch dangerous voltage points or short out parts that could result in a risk of fire or
electric shock Never spill liquid of any kind on the product
10. To reduce the risk of electric shock, do not disassemble this product, but take it to an authorized service facility. Opening or removing parts of the telephone base or handset other than specified
access doors may expose you to dangerous voltages or other risks Incorrect reassembling can cause electric shock when the product is subsequently used
11. Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.
2 Unplug this product from the wall outlet and refer servicing to an authorized service facility under the
following conditions:
A When the power supply cord or plug is damaged or frayed
B If liquid has been spilled onto the product
C If the product has been exposed to rain or water
D If the product does not operate normally by following the operating instructions Adjust only those controls that are covered by the operating instructions, as improper adjustment of
other controls may result in damage and often requires extensive work by an authorized technician to restore the product to normal operation
E If the product has been dropped and the telephone base and/or handset has been damaged
F If the product exhibits a distinct change in performance
3 Avoid using a telephone (other than cordless) during an electrical storm There is a remote risk of electric shock from lightning
4 Do not use the telephone to report a gas leak in the vicinity of the leak
5 Only put the handset of your telephone next to your ear when it is in normal talk
SAVE THESE INSTRUCTIONS
FCC, ACTA and IC regulations
