VTech IP8100-1, Руководство пользователя

Страница: 11 / 42

8
Getting Started
Setup
STEP 4
Connect one end of the blue Ethernet cable to the blue port, labeled “WAN,”
located on the back of the base unit and connect the other end of the blue cable
to the Ethernet port on your cable or DSL modem.
STEP 5
Reconnect power cord to the modem then turn the modem on. Please wait until
all lights on the modem stop blinking.
Helpful Hint: This should take a few minutes, but may take as long as 0 min-
utes.
STEP 6
Plug the power cord into the power port located on the bottom or your IP800
series telephone and the other end into the electrical outlet. This turns the IP
800 series broadband telephone on.
Helpful Hint: DO NOT interrupt this registration process by unplugging the pow-
er or by using the handsets until the READY indicator light on the front of IP800
series base has gone from flashing yellow to a steady green.
Helpful Hint: Use only the power cord provided in this package; using an older
power cord can damage the broadband telephone.
STEP 7
Turn your computer on, and check your computer to see if your Internet is work-
ing, try to visit any website. If your Internet is working, please proceed to STEP
0. If not, please proceed to STEP 8.
STEP 2
Disconnect all cables between your Cable or DSL modem and your computer.
STEP 3
Connect one end of the yellow Ethernet cable to the yellow port, labeled “PC/
LAN,” located on the back of the base unit and connect the other end of the yel-
low cable to the Ethernet port of your computer.
STEP 8:
Cable Users
If you receive Internet access through a Cable modem, you may need to register
the IP800 series telephone with your ISP. Please contact them to update your
information; you will likely need your WAN MAC address, which is located on
the bottom of the IP800 series telephone. Once your ISP has updated your
account, proceed to step 9.
-- OR --