14
To set static IP when initially setting up the deskset:
Instructions on this page are for users to enter static IP to set up the
deskset, due to a failure in obtaining IP from the Ethernet switch or
router automatically. If you have successfully obtained the IP from your
Ethernet switch or router, you do not need to perform the steps below.
1. If the deskset cannot obtain an IP address from the Ethernet switch or router
after you power it up, the screen displays
No IP obtained. Check network
,
then displays the network setup menu.
2. Press or to scroll to
Set static IP
, then press
MENU/
SELECT
.
3. The screen displays
Enter static IP
Use the dialing keys to enter a
specific IP.
•
Press
DELETE
to delete a character.
•
Press
#
to add a dot.
•
Press
/REPEAT
or
/SKIP
to move the cursor to the left or right.
When entering a specific IP, make sure the IP range is not blocked by the
Ethernet switch or router. If you are installing more than one deskset in the
system, keep the first three sets of digits consistent and the last one different
among different desksets. For example, if you enter 192.168.1.1 as the static
IP of the first deskset, make sure the first three sets of digits are also set as
192.168.1 in other system desksets.
4. Press
MENU/
SELECT
. The screen displays
Subnet mask:
Use the dialing
keys to enter a specific subnet mask.
•
Press
DELETE
to delete a character.
•
Press
#
to add a dot.
•
Press
/REPEAT
or
/SKIP
to move the cursor to the left or right.
5. Press
MENU/
SELECT
. The screen displays
Router/Gateway:
Use the dialing
keys to enter a specific gateway.
•
Press
DELETE
to delete a character.
•
Press
#
to add a dot.
•
Press
/REPEAT
or
/SKIP
to move the cursor to the left or right.
6. Press
MENU/
SELECT
to save. The screen displays
IP obtained: XXX.
XXX.X.XXX Press SELECT to proceed
, press
MENU
/SELECT
.
7. The deskset displays
Enter the name of the Console connecting to this
phone.
Press
MENU
/SELECT
.
(Continued on next page)
Getting started
Deskset installation (set static IP)
