EN - 36
Appendix
FCC, ACTA and IC regulations
FCC Part 15
This equipment has been tested and found
to comply with the requirements for a Class
B digital device under Part 15 of the Federal
Communications Commission (FCC) rules.
These requirements are intended to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to this equipment not
expressly approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
This Class B digital apparatus complies with
Canadian ICES-003. CAN ICES-3 (B)/NMB-3(B)
FCC Part 68 and ACTA
This equipment complies with Part 68 of the FCC
rules and with technical requirements adopted
by the Administrative Council for Terminal
Attachments (ACTA). The label on the back
or bottom of this equipment contains, among
other things, a product identifier in the format
US:AAAKXNANXXXX. This identifier must be
provided to your telephone service provider
upon request.
The plug and jack used to connect this equipment
to premises wiring and the telephone network
must comply with applicable Part 68 rules and
technical requirements adopted by ACTA. A
compliant telephone cord and modular plug is
provided with this product. It is designed to be
connected to a compatible modular jack that is
also compliant. An RJ45 jack should normally
be used for connecting to a single line. See the
installation instructions in the user’s manual.
The Ringer Equivalence Number (REN) is used to
determine how many devices you may connect
to your telephone line and still have them ring
when you are called. The REN for this product is
encoded as the 6th and 7th characters following
the US: in the product identifier (e.g., if ## is 03,
the REN is 0.3). In most, but not all areas, the
sum of all RENs should be five (5.0) or less. For
more information, please contact your telephone
service provider.
This equipment may not be used with Party
Lines. If you have specially wired alarm dialing
equipment connected to your telephone line,
ensure the connection of this equipment does
not disable your alarm equipment. If you
have questions about what will disable alarm
equipment, consult your telephone service
provider or a qualified installer.
If this equipment is malfunctioning, it must be
unplugged from the modular jack until the
problem has been corrected. Repairs to this
telephone equipment can only be made by the
manufacturer or its authorized agents. For repair
procedures, follow the instructions outlined under
VTech Hospitality limited warranty program
in
