●
If the soft starter starts n o t g o o d , y o u c a n c h e c k w h e t h e r t h e starting
mode you choose is suitable for your motor.
Please refer to the detailed explanation at 7.2: the starting mode and application
●
If the starting torque of the motor is not big enough, you can increase the
starting voltage ( in voltage control mode) or enlarge the limit-current value
( in current control mode) to enlarge the starting torque.
●
It
is forbidden to open the upper cover after powered on,
otherwise electric shock may be caused.
●
If there is any abnormal voice, smoke or smell , please cut off the electricity
immediately to check and find out the reasons.
●
After power on or starting, if the fault-lamp is onand screen displays” Err××",
Please check the Form 7.1 to find out the reason according to the error code.
restoration
external stop key
Note :
When the temperature is below -10
℃,
the starter should be started
after preheated for 30 minute with power on.
●
It
can
back
to
the
to press
the
stop or the
Fault and Solution (Form 7.1)
Note
:When the motor starts successfully , the by-
-lamp will be l
ighting, that means the by-
contactor is running . At this time,
if the contactor is not closed, the motor will stop running, please
check if the connection of the
pass contactor is right or not.
7.2The starting mode and application
There are six starting modes for the user to choose according the motor
and load equipments, as the following:
pass
pass
by-
VTdrive
VTdrive
www.vtdrive.com
www.vtdrive.com
25
26
