FLOW-meter Version: 1.0
Page 26/29
2.7.1.2
PAGE 2 (System – settings)
FUEL
the current FUEL value according to the following settings:
Pulses/1000ml
Parameter for adapting the FLOW-meter electronics to the respective flow sensor (s. section
2.0.3 Calibration).
Reset Power ON
aktiv:
Each time the receiving system is switched on, the consumption / tank indicator
FUEL is reset to 0 ml (FUEL display = consumed) or to FUEL Tank Size
(FUEL display = level).
deaktiviert:
The last FUEL value is stored and is available again after the receiver is
switched on again until a reset is carried out.
Reset (channel)
not used, Servo 1, Servo 2, . . . Servo 26
Servo channel for resetting the FUEL value, Reset for servo value > 80%.
Name
It can be connected simultaneously several FLOW-meter at P²Bus, for example, in multi-
beam models. The assignment of the sensor address manages the PowerBox transmitter -
please read this in the manual of your PowerBox transmitter.
To distinguish between several simultaneously active FLOW-meters, different names can be
selected for Sensor Name, for example:
FLOW-meter FLOW-meter[1] [2] [3] [4] [A] [B] [C] [D] [L] [M] [R] . . .
Priority
Here you can set the prioritization of the data request for FUEL and FLOW, you can choose
between:
low / high / higher / at highest - whereby low is sufficient.
Version #.#
Current software version.
Calibrate
As an alternative to the button on the FLOW-meter,
Auto calibration
(see section 2.0.3.1)
can be activated (started) and deactivated (ended) here. With activated calibration "calibrate"
in FUEL is displayed.
