THE ELITE CLIP / TOOL TIPS
15
position the large top blade on top of the small bottom blade by matching them
up, point to point. The blade teeth on the large top blade should be 0.5mm to
1.2mm back from the small bottom blade (see Fig.1).
5. Finally, before fully tightening the two screws in the large blade, to avoid injury
ensure that the blades are correctly aligned. With the taper control lever fully
forward, the tips of the small blade must be parallel with and 1mm below the tips
of the large blade. Also check that the extreme left hand tooth of the small blade
is inside the large blade. (Failure to do so could cause injury).
6. Carefully tighten the two screws on the large top blade, taking care not to disturb
the above correct position of the blades
7. After replacing the blade set, always remember to re-oil the blades of your
clipper.
NOTE:
Use the blade guard provided to protect the blades from damage. In the event
that the blades become blunt or damage through misuse, contact Conair Customer
Service. Replacement blades, comb guides and power leads can be purchased from
our Service Centre.
Fig. 1
0.5mm - 1.2mm
P
CORRECT
