A
A’
B
B’
Trial fit the horizontal stabilizer in place on the fuselage. Check the alignment
of the horizontal stabilizer. The distance must be equal on both sides
(A=A’ and B=B’ and C=C’)
. If not, adjust the stabilizer until the measurements
are the same.
If the fit is overly tight, it may be necessary to
lightly sand the hole on the fuselage.
SECTION 10 - HORIZONTAL STABILIZER
Step 10A
Note: Turn the plastic bolts on the left and right
side of the fuselage, full the canopy hatch out
of the fuselage first.
* WARNING: When removing any covering from the airframe, please ensure that you secure the
cut edge with CA or similar cement. This will ensure the covering remain tight.
Cut away only
the covering*
Step 9D
5x20mm screw
SECTION 9 - JOINING THE WING continued
C
C’
5x20mm screw
...1 (for each side)
