Relieve the cowl to
clear the engine head
2.5x10mm.....4
3/32x13/32”
2mm
Connector
........ 3
X
Rudder pushrod
3mm set Screw
2 mm
Elevator or rudder servo
(Or elev. pushrod)
When you are satisfied with the alignment of the control horn mark the
mounting hole positions with a felt tipped pen or a pencil.
Remove the control horn and drill two 2mm (5/64”) holes through the rudder
and elevator.
Attach the rudder and elevators control horn using two 5/64X15/32”(2x12mm)
screws and a back plate.
3/8 in. (9.5mm)
................3
2x12mm screw
..........6
Right elevator servo (mini servo)
Left elevator servo
Rudder servo (mini servo)
Apply a thin layer of machine oil or petroleum jelly to only the
top and bottom of the trailing edge of the elevator
, then
push the elevator and its hinges into the hinge slots in the
trailing edge of the horizontal stabilizer.
When satisfied with the and alignment, hinge the elevator to
the horizontal stabilizer using CA glue.
Do the same way with the rudder.
Hinge
Petroleum jelly
STABILIZER
Thin CA glue
2mm
FUEL TANK OR LI-PO BATTERY AREA
Throttle servo hole
Throttle servo hole
FUSELAGE - TOP VIEW
20- SERVOS AND LIKAGES
21- COWLING
22- BATTERY&FUEL TANK AREA
