VPG SI Onboard 9150, Руководство пользователя

Страница: 28 / 45

25
Calibrating the EMPTY and FULL weight
This section does not apply to a true axle load truck
configuration. See separate description below.
Select Empty Vehicle or Loaded Vehicle in the
Calibration Wizard.
The display will show the current weight and the roll
and pitch angles for the current Smart box.
Select the channel being calibrated using F3
(Previous) or F4 (Next).
Press F2 (Calibrate) and enter the weight noted from
the scale. Use the arrow keys to set the weight value
on the Meter.
Press F4 (Next) when the weight is entered.
The Meter will show a message “Calibrating, please
wait!” during a few seconds while the channel is being
calibrated.
If calibration is correctly performed the empty or
loaded vehicle screen is shown again and next
channel can be selected.
If there is any problem or error before or during
calibration a message is displayed. Correct the error
and try again.
Entering weight values true axle load
The display will show the current axle weights and the
roll and pitch angles.
Empty
•Make sure the truck or trailer is completely
empty before beginning this procedure
•Be sure the weight includes a full load of fuel
•Note the weight value for each axle or channel
weighed using a platform scale
Full
•Make sure the truck or trailer is loaded to
capacity before beginning this procedure
•Note the weight value for each axle or
channel weighed using a platform scale
Press F1 (Escape) to
quit the calibration
wizard. It is always
possible to continue with
calibration at a later
occasion