VTAC USER MANUAL
VPC
10/10/2022
For more information visit vpc.com
7
TOOLS REQUIRED
Phillips Head Screwdriver
INSTALLATION
1.
To install VTAC Adapter Rails into the i2 MX Receiver or ITA, first separate the
two halves of the frame by unscrewing the Phillips head screws
(Figures A
and B)
. Rails are installed in the bottom portion of the frame.
2.
Identifying marks on each set of rails are present to ensure correct
orientation is used during installation (
Figure C
).
•
The receiver rails are marked with ‘RR’ (Receiver Right) and ‘RL’ (Receiver
Left). The left and right sides are determined as such, when viewing from
the mating face of the receiver.
•
The ITA rails are marked with ‘IR’ (ITA Right) and ‘IL’ (ITA Left). The left
and right sides are determined as such, when viewing from the rear/
wiring side of the ITA.
3.
After rails are installed, place frame bottom on a flat surface, then re-fasten
halves together by re-tightening the Phillips screws.
REMOVAL
1.
Before separating the receiver or ITA into two halves for rail removal,
the receiver may require removal of a strain relief plate first (
Figure A
). If
installed , the ITA will require removal of the backshell.
2.
After removing a strain relief or backshell, remove screws securing frame
halves together (
Figures A and B
).
3.
Once the two halves are separated, the rails may be removed.
i2 MX VTAC RAIL INSTALLATION/REMOVAL
PART # 310 130 114, 310 130 121, 310 130 120, 410 130 116, 510 144 001, 510 143 001
Figure A.
Receiver frame separation
PHILLIPS
FLAT HEAD
SCREWS (2)
Figure C.
Receiver rails.
‘RR’ RECEIVER
RIGHT
‘RL’ RECEIVER
LEFT
BLACK POSITION A1
INDICATOR
Top
Bottom
TOP OF
RAIL
Figure B.
ITA frame separation.
PHILLIPS
CAPTIVE
SCREWS (2)