VTAC USER MANUAL
VPC
10/10/2022
For more information visit vpc.com
9
Figure C.
Extraction
PUSH
PLUNGER
IN
FRONT OF
MODULE
Figure B.
PROPERLY
SEAT
EXTRACTION
TOOL PINS
INSIDE
MODULE
GRIPS
PLUNGERS
Figure A.
BLUE INSERT ON
TOP ( INDENTED
CIRCLES ON TOP)
INSTALLATION
1.
Ensure the VTAC Insert(s) is in line with the corresponding module slot(s). Inserts are
installed from the rear side of the ITA module. Place the insert in with the (3) circular bosses
facing down(
Figure A
). When installing a patchcord containing multiple VTAC inserts, the
blue insert should always be installed on top (
Figure A
).
2.
Load module beginning at the top and moving downward.
3.
Apply gentle pressure and the insert(s) should easily snap into place. Force should
not be needed when inserting. If force is required, incorrect orientation is being used
for installation. Consult the VTAC Insert Feature Identification page in this manual for
assistance with proper installation orientation.
4.
The insert(s) is fully seated when the rear of the tool(s) is flush with the rear edge of the
module frame (
Figure B
).
REMOVAL
5. All inserts grouped together for a patchcord, must be extracted at the same time.
6.
The VTAC Extraction Tools should be grouped together to allow for removal of multiple
inserts simultaneously. Each tool is magnetized and grooved to make grouping easier.
7.
The extraction tool is used on the front side of the ITA module. Grasp the tool(s) from
the sides and slide the tool pins into the square cavity holes located on the inside of the
module frame on either side of the insert(s) to be removed (
Figure B
). If using multiple
tools simultaneously, make sure that all pins are properly inserted into each corresponding
cavity. The tool frame should be seated against the frame body if pins are inserted correctly
and completely (
Figure B
).
8.
Tool(s) must be seated against the module frame before the plunger is pushed in. Otherwise
damage to insert(s) may occur. Push plunger in fully. The insert(s) should be ejected out the
opposite side of the module (
Figure C
).
9.
Force should not be needed to extract inserts. If inserts do not extract easily, ensure all tool
pins are fully seated in the correct location and try again.
INSERT INSTALLATION/REMOVAL SIM MODULES- ITA
PART # 510 171 101, 910 112 130
TIER A
TIER B
