PA-1008 WARNING
:
The PA-1008 is designed for INDOOR and OUTDOOR use.
The PA-1008 blades revolve at high speeds and can cause
damage to the user, spectators and animals. Stand away from the PA-1008 to reduce the risk of getting into the flight
path. Warn spectators that you will be flying your PA-1008 so that they are aware of its position. Before flight, inspect the
rotor blades to make certain that the blades are securely fastened to the PA-1008.
WARNING!
• Choking/Cutting Hazard. Small Parts/Sharp Rotor Blades.
• Keep hands, hair and loose clothing away from the propeller when the power switch is turned to the ON position.
• Turn off the transmitter and PA-1008 power switches when not in use.
• The included charger is built specifically for the PA-1008 Li-Poly battery. Do not use it to charge any other battery.
• New alkaline batteries are recommended for maximum performance.
• Parental supervision recommended when flying PA-1008.
BATTERY WARNINGS
R
ECHARGEABLE BATTERY:
This PA-1008 uses a Li-Poly rechargeable battery. If battery no longer stays charged, dispose of battery properly according
to local disposal requirements.
CONTROLLER BATTERIES:
Remote control requires 2 “AAA” batteries (not included). Please read the important battery safety warning below.
• Do not mix alkaline, standard (carbon-zinc) and rechargeable batteries (nickel metal hydride).
• Do not mix old and new batteries.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the item before being charged (if removable).
• Rechargeable batteries are only to be charged under adult supervision.
• Exhausted batteries should be removed immediately and must be recycled or disposed of properly according to state or
local government ordinances and regulations.
• The supply terminals are not to be short-circuited.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity (see inside booklet for diagram).
• Do not dispose of batteries in a fire - batteries may leak or explode.
CARE AND MAINTENANCE
• Always remove the batteries from the wireless remote control when it is not being used for an extended period
of time.
• To clean, gently wipe the remote control and PA-1008 with a clean damp cloth.
• Keep the toy away from direct heat or sunlight.
• Do not submerge the toy into water. This can damage the unit beyond repair.
• Parental guidance recommended when installing or replacing the batteries.
HOW TO DO 360º STUNT ROLLS
1. In order to make your PA-1008 do 360º rolls you must fully charge your battery.
Note: The PA-1008 will not do 360º stunt rolls in T mode and Mode 1 or under low battery indication
(The LED lights on the drone will be flashing).
2. Once you are ready to attempt a 360º roll, simply depress and let go of the "STUNT" button on the top
right hand side of your controller (see Remote Diagram on page 3). You will hear beeping sounds, this
means you are now in “STUNT MODE."
3. Now quickly move your right control stick in any of 4 directions; up, down, left or right. Your PA-1008
drone will instantly roll in the associated direction. See diagram below.
Note
:
After performed the stunt roll, the beeping sounds will stop. Repeat step 2 to 3 if you wish to do it
again.
If the PA-1008 becomes unstable during the course of flying,
you may need to calibrate the internal gyros. To do this place
the PA-1008 on a flat level surface. Do not start the blades.
Instead move both the throttle and control stick down and to
the right corner . The LEDs on the PA-1008 will flash quickly
and then remain solid, this indicates your drone has been
recalibrated (see diagram E).
REPLACING THE PROPELLER BLADE
Your PA-1008 propeller system is a precision instrument that may need repair or replacement from time to
time for optimal flight function. Crash landing from high-speed aerial flights may cause damage to
your PA-1008 propellers.
1. PA-1008 has four blades, two gray propellers on the front and two black propellers on the back.
2. When taking off the damaged blade, always use the included blade wrench. Refer to the instruction
diagrams below. Always use mild force, be gentle!
3. When replacing the new blades, make sure to match the indicating letter embossed on the blades to
the diagram below.
Rear
Front
A
A
B
B
9
10
F
360˚Stunt Roll
G
CALIBRATING THE PA-1008
Blade Front Left = A
Blade Front Right = B
Blade Rear Left = B
Blade Rear Right = A
E
