9
DS4+ HONDA7
© 2021-11-24 VOXX•DEI LLC. All rights reserved.
Module programming
Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
To connect the module:
1
Ensure vehicle is in a safe location and cannot move forward during programming. For vehicles
equipped with a manual transmission, make sure the gearshift is in the neutral position.
2
Connect the 12-pin main power harness to the module.
DS3+: Wait until the LED turns on solid red then proceed to the next step.
DS4+: The LED turns ON solid blue for 1 second to confirm Bluetooth communication.
Wait until the LED turns ON solid red, then proceed to the next step.
4
2
4
4
2
22
8
10
12
Must connect
12-pin FIRST
Solid
Solid
DS3+
DS4+
Solid
1 Sec
OR
3
Connect the remaining harnesses to the module.
Connect
remaining
harnesses
4
Press once (1) on the Push-to-Start (PTS) button to turn the ignition ON, and wait until the LED turns
OFF.
&
Off
5
Press once (1) more on the PTS button to turn the ignition OFF.
6
Pair remotes (if applicable).
Pair
remotes*
AFTERMARKET
7
DATA/Hardwired Tach Learning: When using Data Tach, it is recommended to follow
the Tach Learning procedure; however, when using a Hardwired Tach, the procedure
is mandatory.
For more information, refer to the Tach Learning procedure section.
Initialize
tachometer
TACH
0
1
2
3
4
5
6
7
8
* Your aftermarket remote may differ from the model shown in the illustrations. For information on how to pair a specific remote, please refer
to its corresponding owner documentation, which can be found inside the product packaging of the complete system or on
www.directechs.com.
You have successfully completed the module programming sequence.
