Voxelab Aquila X2, Руководство пользователя

Страница: 26 / 32

Printing notice
！
The adhesion of glass build plate may decrease after long time using. Please apply proper amount of glue to keep and improve the adhesion.
Warping issues may occur when print ABS filament in cold environment, you may use glue to enhance the adhesion. It's not recommended to print
ABS filament at extremely low temperature environment, as print will easily fail with model break away from the build plate.
There is a certain quivering on the build plate during the printing which may cause the flatness to change. Thus please pay attention to the adhesion
of the first layer when printing the second model; if the distance of build plate and nozzle is not right, please re-level it.
If prints' accuracy is not right, check the status of synchronous belt, adjust it if too loose or too tight. If synchronous belt is working correctly, check the
transmission ratio under Setting. Turn up the transmission ratio if the size gets smaller, turns down the ratio if the size gets larger.
If the accuracy of Z-axis height dimension is not good enough, check out the compensation setting of Z-axis for precision compensation.
If the build plate shakes, adjust tightness of the pulley using a wrench and slowly slide the build plate to see whether all four wheels under it rotate.
Stop moving the pulley only when the build plate is steady.
If XZ components shakes, adjust the distance between the pulley and the structural section properly using an open-end wrench; the wheel can be
rotated by hand.
Optimal temperature for printing is 18~30℃. Print quality will be affected if ambient temperature is too high or too low.
1.
2.
3.
4.
5.
6.
7.
8.
25