Voxelab Aquila X2, Руководство пользователя

Страница: 19 / 32

Bed Leveling
Nozzle is too far away from build plate
that model cannot adhere to the build
plate.
Perfect distance between nozzle and
build plate ensures even filament
adheres right on the build plate.
Nozzle is too close to build plate that
cause filament failed to sufficiently
extruding. Nozzle may easily be
damaged and clogged, build plate
may be scratched.
0.1mm
After adjusting the upper
position of the 4 nuts, check
the center position again.
Note:
18
1. Move the extruder on the top of the leveling nut. Screw the nut and adjust the distance between the nozzle and the
build plate. The distance is around 0.1mm. (Thickness of a piece of A4 paper)
2. Use a piece of A4 paper to assist in leveling, so that the nozzle can just scratch the A4 paper lightly. Adjust the leveling
nuts on the four sides in turn until you can feel the slight resistance from the nozzle when pulling the A4 paper.
3. Test the distance between the nozzle and the print platform is enough or not. Repeat the above steps 1-2 times if
necessary.
If adjusting rotating nuts cannot make the nozzle
touch the build plate, the position of the z-axis limit
switch may be too high. Adjust accordingly.