Vox VTX150 neodymium, Руководство пользователя

Страница: 16 / 44

16
NOTE:
Depending on the guitar you’re using, raising the noise reduction
too high may cause notes to be cut off.
3.
Press the TUNER (BYPASS) switch to make the TUNER (BYPASS) LEDs go dark.
Saving a program
When you’ve created a sound that you like, here’s how to save (write) it.
HINT: If you’re saving to a channel in the same bank, proceed from step 3.
1.
Hold down the BANK switch for 0.5 seconds or longer. The BANK LED will
blink.
2.
Press the BANK switch to select the save-destination bank.
HINT: If an optional (separately sold) VC-12SV foot controller is con-
nected, you can use the controller’s BANK UP/DOWN switches to select
the save-destination (banks 1–4).
HINT: If you decide to cancel the Write operation, press the TUNER (BYPASS)
switch at this point. The LED will stop blinking, and you’ll return to the
previous mode.
3.
For two seconds or longer, hold down the CHANNEL switch of the channel in
which you want to save the sound. The LED will change from blinking lit. The
program will be saved in that channel, and that bank and channel will be
selected.
NOTE: The program that was previously in that location will be overwrit-
ten; i.e., the program that had been in the channel you selected in step 3
will be lost.
NOTE: The setting of the TUNER (BYPASS) switch is not saved in the
program.
NOTE: If you’re creating your sound in Preset mode or Channel Select
mode, the changes that you made will be lost if you switch to another
program, to Manual mode or turn off the power before saving.
Checking the original values saved in a program
The original value indication lets you check the parameter settings that are
saved in a program.
When you turn a knob to change the value of a parameter, the PRESET LED (if
you’re in Preset mode) or the LED of the selected channel (if you’re in Channel
Select mode) will momentarily go dark when the edited value matches the
value that’s stored in the program.