Vox Valvetronix, Руководство пользователя, Страница: 9 / 61

5
from scratch. We’re gonna take the easiest of the two options (and they’re
both pretty simple!) and go through the factory presets first BUT hey, if
you’d rather start by writing a program of your own right off the bat, skip to
the “STARTING FROM SCRATCH” section that starts on page 23 and carry
on from there...
6. Let’s start at the very beginning by playing program 1-1 which is a fat, easy
to play, high gain lead sound called “Flying High.” First though, let’s reset
your amp to the factory presets, just incase someone has messed with
‘em...and don’t panic, it’s a piece of cake!
IMPORTANT NOTE: If you do a “factory preset recall” you’re gonna permanently
erase all the programs you may have already written/tweaked yourself. So please
make double sure that you don’t mind losing your programs before you reset your
Valvetronix’s memory to its “virgin,” factory default state...’cos once you do a “reset”
there’s no turning back!
ANOTHER IMPORTANT NOTE: If there are some programs you’ve written that
you’d like to remember, jot ‘em down on the “Programmer’s Cheat Sheet” that can be
found on the back of the fold-out rear cover of this manual before you “reset” the
amp. See the “ORIGINAL VALUE LED” section on page 26 if you wanna know how
to do this.
7. Hold down the Up (
▲
) and Down (
▼
) Cursor Buttons (the ones right next to
the BANK DISPLAY window) and the TUNER/CANCEL Button that is next to
‘em and, while you’re holding all three of them down at the same time,
switch the amp’s POWER Switch to the “ON” position. If you’ve done this
correctly, a “
” will be flashing in the BANK DISPLAY window so move on
to STEP 8.
8. If a “ ” isn’t flashing - don’t fret. Just switch the amp off and try
again...making sure you’re holding all three buttons down when you hit the
POWER SWITCH this time! The “
” is flashing in the BANK DISPLAY win-
dow now, right? Good!
9. Press the WRITE Button (just above the TUNER/CANCEL one) and watch the
BANK and the CHANNEL Button lights do a little dance. Once they both stop
jumping, you’re done...your reset mission is a success. And, as luck would
have it, doing this leaves your amp armed and ready with the exact program
we’re looking for: 1-1! See, I told you it was easy!! So, get ready to rock by
switching your guitar’s pickup selector to the lead (bridge) position and
turning its Volume and Tone controls up full. Right, let’s go “Flying High,”
bro...