Vox Valvetronix, Руководство пользователя, Страница: 31 / 61

27
STEP 3: Now that we’ve found which PEDAL is being used, let’s find where
the DRIVE Control for it is set. So, watch the ORIGINAL VALUE
LED and slowly but surely sweep the DRIVE Control through its
full range of motion. When you reach the setting, the ORIGINAL
VALUE LED will tell you.
STEP 4: Do the same thing with the LEVEL Control in the PEDAL Section.
STEP 5: The AMP SECTION is next. Let’s find out what model’s being used
by slowly clicking the AMP TYPE Selector Switch through the 16
choices while keeping an eye on the ORIGINAL VALUE LED.
When you reach the one that’s being used the ORIGINAL VALUE
light will either go on or off for a second, depending on whether the
BYPASS button is engaged or not. Wow, easier than falling off a
log isn’t it? And far less painful too!
STEP 6: Right, we’ve found the amp model, now let’s figure out where each
of the programmable amp controls are set - namely, GAIN, VOL-
UME, TREBLE, MIDDLE, BASS and PRESENCE. Let’s start with
GAIN and move right, one knob at a time...and you already know
what to do, right? Yes, you’ve got it - slowly but surely rotate the
GAIN control through its full range of movement while keeping an
eagle eye on our helpful pal, the ORIGINAL VALUE LED. When
you reach the setting, the ORIGINAL VALUE LED will let you
know.
STEP 7: Do exactly the same for the VOLUME, TREBLE, MIDDLE, BASS
and PRESENCE controls...duh!
STEP 8: So, we’ve already done the Pedal and Amp Sections, now all that’s
left are the three sections in our “virtual effects loop” - MODULA-
TION, DELAY and REVERB. Let’s start with MODULATION -
ignoring the EX CTL LED, is an LED lit up in this section? If an
LED is “on” it means the effect it’s next to is being used so we
need to find out where the SPEED and DEPTH controls are set for
the effect in question. And you know what to do by now when it
comes to finding the “original setting” for a control knob don’t you!?
So start twisting a way on that fine pair of knobs and keep your
eye on the ORIGINAL VALUE LED...
STEP 9: Repeat STEP 8 with the DELAY and REVERB sections.
STEP 10: There isn’t one. You’re done pal! Congratulations - you now know
exactly how the program you were interested in was set up.