5
Owner’s
M
anual
REAR PANEL LAYOUT
1.
FOOT SWITCH Jack
This is where you connect the included Foot Switch (VFS1) to switch
between HOT and COOL modes on the TOP BOOST Channel (HOT
mode must be engaged on the control panel for the Foot Switch to
operate).
2.
EXTERNAL SPEAKER OUT
This is used to connect the AC4HW1 to any 16ohm cabinet.
NOTE:
When an external cabinet is connected, the internal speaker is dis-
connected.
WARNING:
To ensure that your system works correctly, you must observe the
following points.
a) Don’t use an external cabinet whose impedance is other than 16
ohms.
b) Don’t connect a speaker whose rated input capacity is less than 4
Watts. The speaker may be destroyed if you ignore this caution—not
recommended!
c) You must use a speaker cable to connect an external speaker. Don’t
use a shielded cable like the one you use to connect a guitar to an
amp.
d) You must turn off the power before connecting the cable. Connecting
the cable while the power is turned on may damage your amp.
3.
MAINS INPUT
Connect your supplied mains power lead here
NOTE:
Use only the power cable that is included with the AC4HW1. Using
another power cable may cause malfunctions.
The specific mains input voltage rating that your amplifier needs to run
at is located on the rear panel of your amplifier. Before making any
connections or powering up the amplifier, make sure the correct volt-
age is set. If you have any doubt, refer to your local VOX dealer.
1
2
3
