JUMPER SETTING AND CONNECTORS
EM586 / 7
2.2 J
UMPER
S
ETTING
O
VERVIEW
In order to select the operation modes of your system, configure and set the jumpers on
the your Embedded SBC to match the need of your application. To set a jumper, a
black plastic cap containing metal contacts is placed over the jumper pins as designated
by the required configuration as listed in this section. A jumper is said to be “ on ” or
“ 1-2 ” when the black cap has been placed on two of its pins, as show in the figure
below:
A pair of needle-nose pliers is recommended when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your local
sales representative before you make any changes. In general, you simply need a
standard cable to make most connections.
2.3 I
NSTALLING THE
SIM M
ODULE
:
A SIM module simply snaps into a socket on the system board. Pin1 of the SIM module
must correspond with Pin1 of the socket.
1. Position the SIMM above the socket with the “notch” in the module aligned with the
“key” on the socket.
2. Seat the module at a 45 angle into the bank. Make sure it is completely seated. Tilt
the module upright until it locks in place in the socket.
Pin1
Notch
Key