- 2 -
Installation:
•
Fasten the D+ Simulator to a suitable place on the engine using a clip.
•
The function of the engine must not be impaired by the installation.
•
The vehicle manufacturer’s specifications must be observed.
•
Any installation location can be selected.
•
Attach the clip on the bottom third (opposite the connection side) of the device.
•
Check the device is mechanically secured!
•
Lay cables so that they cannot touch any parts with temperatures over 100°C.
•
Fasten cables without any tensile forces.
•
Fasten cables so that they remain capable of moving on the sensor (mechanical stress).
Connection:
•
Wire the device according to connection diagram.
Note:
The device can be operated either on the starter battery, vehicle battery, Terminal 15 or switch outputs.
The additional voltage detection may need deactivating, see corresponding chapter.
