Votex 750/1 PTO, Руководство оператора

Страница: 38 / 61

Every other use can lead to danger, therefore never use the Leafblower for any other
purpose.
4. SAFETY REGULATIONS
4.1 General
Read this manual carefully before using the machine. Follow all instructions exactly and
mind the following instructions at all time. Take care that anybody using the machine,
knows and applies the instructions. Children and anyone not able to work with this
machine safely, is not permitted to use the machine.
1. Stickers and markings in this manual and attached to the machine, give important
instructions for a safe use; following these indications serve your own safety! Never
remove them!
2. As a user wear close-fitting clothes/safety glasses and ear protection! Avoid loose
clothes!
3. After switching off, the machine still runs. Don’ t come near the rotating parts before
the machine has totally stopped.
4. Hitch accessories in accordance with regulations and install these only t the
dedicated locations; work safely.
5. Check the complete machine before every use. Only use the machine if all functions
are running well and with undamaged parts.
6. Repair damages immediately, at least before working with the machine again.
7. Never exceed the maximum allowed number of revs of the machine.
8. Take care of good maintenance according to the regulations in this book and to the
current regulations for agricultural machinery.
9. Restrict the use of the machine to the purpose for which it was designed
under ‘conditions for use’ (section 3).
10. Perform maintenance and repair-activities only on a stationary machine.
4.2 Using the PTO drive shaft
1. Observe the regulations as mentioned in the appended manual of the PTO drive shaft.
2. Coupling and uncoupling the drive line is only allowed, if the tractor engine is shut off
and the starter key is removed.
3. Work only with a fully protected drive.
4. Ensure that the required rpm of the machine corresponds with the rpm of the tractor’s
PTO (540 or 1000 rpm).
5. Do not exceed the maximum working length. Be sure that the 2 telescopically drive
shaft halves overlap each other with a minimum of half the pipe length and that there is
always enough overlap to prevent that the PTO drive shaft is being propelled
inaccurately when making turns. Lubricate the drive shaft regularly.
6. Never exceed the maximum allowed working angle of the drive shaft.
7. Follow the lubrication diagram. After each 8 working hours lubricating with a quality
grease is necessary.
8. Use the PTO drive shaft with undamaged tube covers and prevent the covers of the
PTO drive shaft from rotating by attaching the chains onto their dedicated points.
9. Never use the drive shaft without the fixed protection caps on the tractor and machine
side.
8