20
21
FURY
®
HD
5000
SAFETY AND PRECAUTIONS
Do not stare into beam or view directly without laser eye protection.
Staring continuously into beam for prolonged periods of time could
cause harm to your eyes. If used properly, this device is safe for your
eyes and laser eye protection is not needed.
• Use the correct battery (CR2) and proper battery orientation.
• Do not look at sun.
• Do not activate Menu or Measure buttons while aiming at eye or
looking into objective lens.
• Do not disassemble.
• Do not allow children to play with unit.
CAUTION: Use of controls, adjustments or performance of
procedures other than those specified herein may result in
hazardous laser radiation exposure.
CLASS 1 LASER PRODUCT
THIS PRODUCT COMPLIES WITH IEC 60825-1:2007-03 Ed.2.0 AND
IEC 60825-1:2014-05 Ed.3.0
THIS PRODUCT COMPLIES WITH 21CFR SUBCHAPTER J PARTS 1040.10
AND 1040.11 EXCEPT FOR DEVIATIONS PURSUANT TO LASER NOTICE
NO.50 DATED JUNE 24, 2007.
Sheltered Wings, Inc. One Vortex Drive, Barneveld, Wl 53507 October 2018
FCC REQUIREMENTS
The user’s manual or instruction manual for an intentional
or unintentional radiator shall caution the user that changes
or modifications not expressly approved by the party
responsible for compliance could void the user’s authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
