6
7
FURY
®
HD
5000
Mode Selection Display
Menu Button
Measure Button
Properly Focus the Rangefinding
Display and Binocular
For the best views, follow this process to
properly set the display, center focus, and
diopter. Choose an object that is about
20 yards away from you and stay in the
same spot until you have adjusted the
binocular for your eyes.
1. Power up the binocular and close your
left eye.
2. While viewing the rangefinding display
with your right eye, focus your right
eye on the object and adjust the
center focus wheel until the object is
in focus. Leave the center focus wheel
in this position.
3. Then, using the reticle focus
adjustment ring, adjust the reticle
focus to bring the display into sharp
focus. Once this is done, you will
not have to refocus the rangefinding
display again.
4. Close your right eye or cover the right
objective lens with your hand. Looking
at the object with your left eye, adjust
the diopter so the object is in focus.
Make note of this diopter setting in
case you need to set it again. From
this point on, you will only need to use
the center focus wheel.
Adjust Reticle Focus Ring
Mode Selection
Your Fury
®
HD 5000 is factory set to the angle compensating
HCD ranging mode, best target mode, yards, and maximum
brightness. For most users, these are the preferred settings.
To change modes: Press and release the Measure button to
power on and then press and hold the Menu button for at least
four seconds. Once the Mode Selection screen displays, release
the button.
As you progress through Mode Selection, you may exit at any
time and save your settings by pressing and holding the Menu
button for at least four seconds—the Fury
®
will return to
power-up condition.
