Vornado SF-246, Руководство пользователя

Страница: 13 / 16

ENGLISH | 13
Troubleshooting
Unit fails to heat up. Heating
Indicator Light DOES NOT
illuminate.
Unit fails to heat up. Heating
Indicator Light
DOES
illuminate.
Steam output is weak or
intermittent.
Excessive amount of water in
steam.
NOTE: Unit produces moist
steam – it is normal for steam
to contain some amount of
water.
Unit is not plugged in.
Mineral build-up in unit.
Mineral build-up in unit.
Household circuit breaker / ground
fault interrupter has tripped or
blown a fuse.
Unit is damaged or otherwise in
need of repair.
Unit is damaged or otherwise in
need of repair.
Water level in Boiler is running
low.
Boiler is empty.
Water condensation in Steam
Hose.
Boiler has been overfilled.
Plug power cord into electrical outlet.
Refer to Mineral Build-up section
on Page 12 for cleaning procedure.
Refer to Mineral Build-up section
on Page 12 for cleaning procedure.
Reset circuit breaker / ground
fault interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Immediately cease usage and
unplug.
Immediately cease usage and
unplug.
Refer to
Refilling
procedure on
Page 10.
Refer to
Filling with Water
procedure on Page 10.
Point Main Steam Nozzle towards
sink, tub or ground and shake while
pressing Steam Trigger. Continue
until excess water is released.
Filling Boiler with more than 32
oz. (946 ml.) of water interferes
with steam production, resulting in
water condensation in steam.
Drain some water out of Boiler.
Always use included Measuring
Cup to fill Boiler with correct amount
of water (see Page 10 for details).
PROBLEM POSSIBLE CAUSE SOLUTION
Accessories do not stay firmly
connected to Main Steam Nozzle.
Accessories not properly installed.
Unit has not heated to full
operating temperature.
Check to make sure that
accessories are properly connected,
per procedures on Pages 6-9.
Wait until Heating Indicator Light
turns off to begin steaming.
Floor surfaces appear cloudy or
streaky after steaming.
Cloth Cover is dirty.
Hard water residue on floor.
Remove and wash Cloth Clover
(refer to Page 9 for details).
Switch to distilled or
de-mineralized water.