VonHaus 3500127, Инструкция по эксплуатации

Страница: 6 / 16

WARNING
Please read and understand these Safety Warnings, Safety Symbols and Instructions carefully and retain
for future use
TRIGGERING DEVICES
Fastener driving tools are operated
by actuating the trigger using finger
pressure.
In addition, fastener driving tool is fitted
with a safety yoke which enables the
driving operation to be carried out only
after the muzzle of the tool is pressed
against a work piece. Do not use the tool
without an effective safety yoke.
ACTUATING SYSTEMS
Depending on their purpose, fastener
driving tool is fitted with actuating system
of single sequential actuation and contact
actuation.
You could switch to one nail figure to
choose single sequential actuation,
and switch to two nail figure to choose
contact actuation.
• Single sequential actuation: An
actuating system in which the trigger and
the safety yoke have to be activated so
the only one single driving operation is
actuated via the trigger after the muzzle
of the tool has been applied to the
driving location, Thereafter further driving
operations can only be performed after
the trigger has been returned to the non
driving position whilst the safety yoke
remains depressed.
• Contact actuation (restricted version):An
actuating system in which the trigger and
the safety yoke have to be actuated for
each driving operation, with the order of
actuation not being specified .
For repeated driving operations, it is
sufficient if either the trigger remains
activated and the safety yoke is activated
thereafter, or vice versa.
Fastener driving tools equipped with
contact actuation must be marked with
the symbol” Do not use on scaffoldings,
ladders’ and shall not be used for specific
application for example:
when changing one driving location to
another involves the use of scaffoldings,
stairs, ladders, or ladder alike
constructions, e.g. roof laths; closing
boxes or crates; fitting transportation
safety systems e.g. on vehicles and
wagons.
Check prior to each operation that the
safety and triggering mechanism is
functioning properly and that all nuts and
bolts are right.
Do not carry out any alterations to
the fastener driving tool without the
manufactures authorization.
Do not disassemble or make inoperative
any parts of the fastener driving tool such
as the safety yoke.
Do not perform any emergency repairs
without proper tools and equipment.
The fastener driving tool should be
serviced properly and at regular intervals
in accordance with the Manufacturer’ s
instructions.
Avoid weakening or damaging the too,
for example by:
punching or engraving;
modification not authorized by the
manufacturer.
AIR TOOL SAFETY
It is the user’s responsibility to ensure
that other persons in the vicinity of the
work area are also equipped with the
appropriate protective equipment.
Use the correct air hose
Use lightweight hose to connect the tool
to the air compressor.
Most air tools should be fitted with a coil
hose.
Always disconnect and ensure that
your air tool has completely stopped