VonHaus 3500127, Инструкция по эксплуатации

Страница: 5 / 16

WARNING
Please read and understand these Safety Warnings, Safety Symbols and Instructions carefully and retain
for future use
until you have read and understand the
information in this manual. Learn the
tool’s applications and limitations, as well
as the specific potential hazards related
to the tool, to reduce the risk of fire or
serious injury.
Use the tool, accessories and tools bits
etc. in accordance with these instructions,
taking into account the working
conditions and the work to be performed.
Use of the tool for operations different
from those intended could result in a
hazardous situation.
Only use accessories designed for use
with the tool.
Secure the workpiece. Use clamps or a
vice to hold the workpiece as this is safer
than using your hand and frees both
hands to operate the tool.
Do not use the tool if the trigger does not
turn it on and off. A tool that cannot be
controlled with the switch is dangerous
and must be repaired.
Do not force the tool. Always use the
correct tool for your application. The
correct tool will do the job better
and safer at the rate for which it was
designed.
Do not overreach. Keep proper footing
and balance at all times. This will enable
better control of the tool in unexpected
situations.
Disconnect the compressor from the
source and remove the nails/staples from
the tool before making any adjustments,
changing accessories or storing. Such
preventative safety measures reduce the
risk of starting the tool accidentally.
Store idle tools out of reach of children
and do not allow persons unfamiliar with
the tool or these instructions to operate
the tool. Tools are dangerous in the hands
of untrained users. Maintain the tool. Check for misalignment
or binding of moving parts, breakage of
parts and any other condition that may
affect operation. If damaged, have the
tool repaired before use. Many accidents
are caused by poorly maintained tools.
only those fasteners which are specified
in the operating instructions shall be used
in fastener driving tools. The fastener
driving tool and the fasteners specified
in the operating instructions are to be
considered as one unit safety system;
quick action couplings shall be used for
connection to the compressed air system
and the non-sealable nipple must be
fitted at the tool in such a way that no
compressed air remains in the tool after
disconnection;
oxygen or combustible gases shall not be
used as an energy source for compressed
air operated fastener driving tools;
fastener driving tools shall only be
connected to an air-supply where the
maximum allowable pressure of the
tool cannot be exceeded by more than
10% in the case of higher pressure or a
pressure reducing valve which includes
a downstream safety valve shall be built
into the compressed air supply;
only spare parts specified by the
manufacturer or his authorized
representative shall be used in the repair
of fastener driving tools;
repairs shall be carried out only by the
qualified persons or by other experts,
having due regard to the information
given in the operating instructions.
DO NOT direct the adjustable vent
hole to the operator or other person or
animals during the use.