MAINTENANCE
CLEANING THE TOOL
Keep your tool clean at all times. Dirt and dust will
cause internal parts to wear quickly, shortening the
tool’s service life.
Clean the body of your tool with a soft brush or dry
cloth.
CAUTION
Never use caustic agents to clean plastic
parts. If dry cleaning is not sufficient, use a mild
detergent on a damp cloth.
WARNING
Do not allow water to come into contact
with the tool.
If available, use clean, dry, compressed air to blow
through the ventilation holes (where applicable).
Ensure the tool is thoroughly dry before using it.
LUBRICATION
All of the bearings in this tool are lubricated with
a sufficient amount of high-grade lubricant for the
life of the unit under normal conditions. As such, no
further lubrication is required.
GENERAL INSPECTION
Regularly check that all the screws are tight as they
may vibrate and loosen over time.
REPAIRS
WARNING
Repairs should only be carried out by an
authorised technician using identical replacement
parts. Do not attempt repairs yourself.
STORAGE
Store this tool carefully in a secure, dry place, out of reach of children.
7
POWERING ON & OFF
Plug into a suitable mains outlet.
To switch on the Angle Grinder, push the
ON/OFF
SLIDE SWITCH (1)
fully forwards to switch on.
NOTE
For continuous operation, push
the
ON/OFF SLIDE SWITCH (1)
fully
forwards and depress to lock it in
position.
Press the
REAR
of the
ON/OFF SLIDE
SWITCH (1)
to release the locking and
switch off the Angle Grinder.
1
DANGEROUS RESTART
This Product is fitted with a
DANGEROUS RESTART
device. If the power is cut to the product during
use (such as disconnection from the mains) the tool will not power back on when plugged back in.
Unless the tool has been switched off first. This is to prevent a user plugging the tool in without the
user checking the position of the power switch first.
