FAX version 911377_00(3) Page 9 of 12
Install bottom adjusting screw through bottom rod
(Figure 2).
With top latch bolt still retracted,
adjust bottom rod so latch bolt
clears floor and bottom strike.
Turn bottom locking screw in. Do not
over-tighten.
ADJUST RODS
Open door and release top latch bolt as shown
(Figure 1).
Loosen bottom locking screw (Figure 2).
Disconnect bottom vertical rod by
removing bottom adjusting screw.
Loosen top locking screw.
Rotate top adjusting screw clockwise until top latch bolt
is fully extended (Figure 1).
Check top latch bolt for deadlocking (latch bolt should
not push in).
Turn top locking screw in. Do not
over-tighten.
Depress pushbar and release.
Make sure top latch bolt stays retracted as shown.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Latch bolt retracted
(flush with latch case)
Check device operation by opening and closing door
several times from the outside.
Redo adjustment procedure if :
- Top latch bolt is not held retracted
- Bottom latch bolt does not clear
floor and bottom strike
13.
Bottom
latch bolt
(clears floor
and strike)
Figure 3
Figure 4
Figure 1
Top latch bolt
Shown fully extended
Figure 2
Bottom
adjusting
screw
Top
locking
screw
Top
adjusting
screw
Bottom
locking
screw
