8
OPTIONAL EQUIPMENT (98/9975-2 DOUBLE CYLINDER)
Install Cylinder
CL
C
L
a
b
c
d
e
¹⁄₂
” (13 mm)
diameter hole
(Device side only)
Cylinder Mounting Screws
DO NOT over-tighten
#8-32 x
⁵⁄₁₆
” (8 mm)
PPHMS
RHR shown
(LHR opposite)
#8-18 x
³⁄₈
” (10 mm)
PPHSMS
¹⁄₄
” (6 mm)
2
¹⁄₄
”
(57 mm)
Device
Door Cutout for 98/9975-2
“Double Cylinder” Option
_____________________________________________________________________________________________________________
Install Cylinder Adapter Plug Assembly to Mortise Lock
RHR Shown
Opposite Side of Lock
a
b
c
a. Screw cylinder adapter plug assembly
into
lock on device side using a
¹⁄₄
"
(6 mm) square socket driver.
b. Position finger as shown.
c. Tighten cylinder screw to
hold in place.
b
_____________________________________________________________________________________________________________
A lock/unlock label is an available option that can be used with the 98/9975-2, and is sold separately. The labels are applied above and
below cylinder to match door handing.
Manually affi x the label:
Ensure surface is clean of dirt, dust, or oils. Clean with
alcohol if necessary.
Peel the label from the paper backing and apply to the
surface. Minimize handling when applying and use
pressure to burnish label to surface. The adhesive will
require up to 8 hours to achieve the proper bond.
RHR shown
Peel and stick
appropriate set of
labels depending on
door handing. Stick labels
above and below cylinder.
RHR
9975-2
LHR
9975-2
These small labels NOT used
for mortise device.
