4
1
3
2
Position Template as Shown and Mark Vertical C
Align Top and Bottom Templates Along
C
and
Prepare Door
Draw Horizontal Center Line ( ) and Assemble
Device Template
Device
template
RHR shown
(LHR opposite)
39
⁵⁄₈
"
to finished floor
RHR
Vertical
2
³⁄₁₆
"
Standard
backset
For 9927
single and
double door
Or flip template over for:
2
³⁄₄
"
backset
If using a
9927 with a
9975 mortise
device on a
double door
L
See “
Preparation Chart
” on
page 3 for
drill, tap, and cut-out
information
See trim instructions
for pull side door
preparation. Line
X-X
in trim instructions
is same as vertical
device
C
.
L
Top
template
Plastic
template
Bottom
template
4
If Necessary, Remove NL Drive Screw
5
If Using a Cylinder with a Tailpiece, Prepare Device
and Cylinder
With the NL drive screw removed, key locks and unlocks lever, knob, or
thumb piece. For the trims listed below,
REMOVE
NL drive screw.
996L
696TP
990TP
996K
697TP
With the NL drive screw installed, key retracts latch bolt.
DO NOT
remove
NL drive screw for the following applications:
NL, EO, DT trims and 98/99-2 double cylinder devices (i.e. TP-2,
L-2, and K-2).
If the trim being installed is "BE" (i.e. 996L-BE), the trim lock
tumbler on the back of the device must be in the
UP
position
before device is installed. This allows the trim to be unlocked at
all times.
*
*996L-BE
*996K-BE
*E996L
*E996L-BE
*696TP-BE
*697TP-BE
*990TP-BE
NL drive screw
Factory installed on
back of center case
Correct
Orientation
(RHR shown)
Incorrect
Orientation
trim lock
tumbler in
UP position
If necessary,
remove drive
screw and
rotate cam
until trim lock
tumbler is in
UP position,
then reinstall
drive screw
360˚
Tailpiece
Tailpiece guide
Rotate tailpiece
guide to match
tailpiece
Door
Surf
ace
¹⁄₂
"
a. Install tailpiece
guide.
b. Cut tailpiece as
needed.
