Volvo XC60 Twin Engine 2020, Руководство пользователя

Страница: 597 / 714

WHEELS AND TYRES
}}
595
8. Start the compressor by flicking the
switch to position I (On).
WARNING
Never stand next to the tyre when the
compressor is running. If cracks or uneven-
ness arise then the compressor must be
switched off immediately. The journey
should not be continued. Call roadside
assistance for recovery to a tyre centre.
Volvo recommends an authorised tyre cen-
tre.
NOTE
When the compressor starts, the pressure
can increase up to 6 bar (88 psi) but the
pressure drops after approximately
30 seconds.
9. Inflate the tyre for 7 minutes.
IMPORTANT
The compressor must not be operated for
longer than 10 minutes - risk of overheat-
ing.
10. Switch off the compressor to check the
pressure on the pressure gauge. Minimum
pressure is 1.8 bar (22 psi) and maximum
is 3.5 bar (51 psi). Release air using the
pressure reducing valve if the tyre pres-
sure is too high.
WARNING
If the pressure is below 1.8 bar (22 psi)
then the hole in the tyre is too big. The jour-
ney should not be continued. Call roadside
assistance for recovery to a tyre centre.
Volvo recommends an authorised tyre cen-
tre.
11. Switch off the compressor and detach the
electrical cable.
12. Unscrew the air hose from the tyre valve
and refit the dust cap on the tyre.
NOTE
•
After a tyre has been inflated, always
refit the dust cap in order to avoid dam-
age to the valve from gravel, dirt, etc.
•
Only use plastic dust caps. Metal dust
caps can rust and become difficult to
unscrew.
13. Fit the protective cap on the air hose in
order to avoid leakage of the remaining
sealing fluid. Place the equipment in the
cargo area.
14. As soon as possible, drive at least 3 km
(2 miles) at a maximum speed of 80 km/h
(50 mph) so that the sealing fluid can seal
the tyre, and then perform a follow-up
check.
WARNING
Sealant will spurt out of the puncture dur-
ing the first few rotations of the tyre. Make
sure that nobody is standing near the car
and gets the sealing fluid splashed onto
them when the car is driven away. The dis-
tance should be at least 2 metres (7 feet).
15. Follow-up inspection
Connect the air hose on the tyre valve and
screw in the valve connection to the bot-
tom of the tyre valve's thread. The com-
pressor must be switched off.