Volvo XC60 Twin Engine 2020, Руководство пользователя

Страница: 279 / 714

KEY, LOCKS AND ALARM
}}
* Option/accessory. 277
Alarm
*
The alarm provides audible and visual warn-
ings if anyone enters the car without a valid
remote control key or manipulates the starter
battery or alarm siren.
When armed, the alarm is triggered if:
•
a door, the bonnet or the tailgate is
opened
15
•
a movement is detected in the passenger
compartment (if fitted with a movement
detector
*
)
•
the car is raised or towed away (if fitted
with a tilt detector
*
)
•
the starter battery's cable is disconnected
•
the siren is disconnected.
Alarm signals
When the alarm has been triggered, the fol-
lowing happens:
•
A siren sounds for 30 seconds or until the
alarm is switched off.
•
Hazard warning flashers flash for
5 minutes or until the alarm is switched
off.
If the cause of alarm activation is not rectified,
the alarm cycle is repeated up to 10 times
15
.
Alarm indicator
A red LED on the instrument panel indicates
the alarm system's status:
•
LED not lit – alarm not armed.
•
The LED flashes once every other second
– alarm is armed.
•
After the alarm has been disarmed, the
LED flashes rapidly for a maximum of
30 seconds or until ignition position
I has
been activated - the alarm has been trig-
gered.
Movement and tilt sensors
*
Movement and tilt sensors react to move-
ments inside the car, if the window is broken
or if anyone tries to steal the wheels or tow
the vehicle away.
The movement sensor triggers an alarm in the
event of movement in the passenger compart-
ment - air currents are also registered. For this
reason the alarm is triggered if the car is left
with a window or the panoramic roof
*
open or
if the passenger compartment heater is used.
To avoid this:
•
Close the window and panoramic roof
when leaving the car.
•
If the passenger compartment or parking
heater is to be used – direct the airflow
from the air vents so that they do not point
upwards in the passenger compartment.
Alternatively, use a reduced alarm level to
temporarily deactivate the movement and tilt
sensors.
Also switch off the movement and tilt sensors
when the car is being transported on a ferry or
train as these movements may affect the car
and trigger the alarm.
In the event of an alarm system fault
If there is a fault in the alarm system,
the driver display shows the symbol
and the message
Alarm system
failure Service required . In which
case, contact a workshop - an authorised
Volvo workshop is recommended.
15 Applies to certain markets.