Volvo V90 2019, Руководство пользователя

Страница: 553 / 674

WHEELS AND TYRES
}}
551
WARNING
Please keep the following points in mind
when using the tyre sealing system:
•
The sealing fluid bottle contains 1) rubber
latex, natural and 2) ethanediol. These
substances are harmful if swallowed.
•
The contents of this bottle may cause
allergic skin reactions or otherwise be
potentially harmful to the respiratory tract,
the skin, the central nervous system, and
the eyes.
Precautions:
•
Store out of the reach of children.
•
Harmful if ingested.
•
Avoid prolonged or repeated contact with
the skin. If sealing fluid has come into
contact with your clothes, remove them.
•
Wash thoroughly after handling.
First aid:
•
Skin: Wash affected areas of skin with
soap and water. Get medical attention if
symptoms occur.
•
Eyes: Flush with plenty of water for least
15 minutes, occasionally lifting the upper
and lower eyelids. Get medical attention if
symptoms occur.
•
Inhalation: Move the exposed person to
fresh air. If irritation persists, get medical
attention.
•
Ingestion: Do NOT induce vomiting
unless directed to do so by medical per-
sonnel. Get medical attention.
•
Disposal: Dispose of this material and its
container at a hazardous or special waste
collection point.
WARNING
•
Do not remove the bottle when the punc-
ture repair kit is being used.
•
Do not remove the air hose when the
puncture repair kit is being used.
1. Set up the warning triangle and activate the
hazard warning lights if a tyre is being sealed
in a trafficked location.
If the puncture was caused by a nail or simi-
lar, allow this to remain in the tyre. It helps to
seal the hole.
2. Detach the decal for maximum permitted
speed that is affixed on one side of the com-
pressor. Affix it visibly on the windscreen as a
reminder to observe the speed limit. You
should not drive faster than 80 km/h
(50 mph) after the emergency tyre repair kit
has been used.
3. Check that the switch is in position 0 (Off),
and locate the electrical cable and the air
hose.
4. Unscrew the orange-coloured cap from the
compressor, and unscrew the cork from the
sealing fluid bottle.
5. Screw in the bottle to the bottom of the bot-
tle holder.
The bottle and the bottle holder are equip-
ped with a reverse catch to prevent sealant
leakage. When the bottle is screwed in it
cannot be unscrewed from the bottle holder
again. The bottle must be removed at a work-
shop
8
.
WARNING
Do not unscrew the bottle, it is equipped with
a reverse catch to prevent leakage.
8 An authorised Volvo workshop is recommended.