Volvo KAD44P, Инструкция

Страница: 64 / 80

62
Bringing out of storage
●
Check oil level in the engine and drive/reverse
gear. Top up if necessary. If there is inhibiting oil
in the system drain and fill with new oil, change oil
filter. For correct oil grade: See the chapter “Tech-
nical Data”.
●
Drain the antifreeze from the seawater system.
●
Install the impeller in the seawater pump (replace
if the old one looks worn).
●
Close/tighten drain cocks/plugs.
●
Check the tension and condition of the drive belts.
●
Check the condition of rubber hoses and tighten
hose clamps.
●
Check engine coolant level and antifreeze protec-
tion. Top up if necessary.
●
Connect the fully charged batteries.
●
Paint the drive and hull: See next page.
●
Check the sacrificial anode on the drive. If there is
less than 2/3 of the anode left it must be replaced.
Clean with emery cloth just before the boat is
launched.
IMPORTANT! Do not use a wire brush or other
steel tools when cleaning, as these may damage
the galvanic protection.
●
Install propellers.
●
Launch the boat. Check for leaks.
● Vent and lubricate the propeller shaft seal (reverse
gear).
●
Start the engine. Check that there are no fuel, en-
gine coolant or exhaust gas leaks and that all con-
trol functions are operating.