20
M8601227
Reinstall the foam rubber and plastic on the inside of the bumper
Pull through the sensor cable and secure it in the in position
along the plastic
Press the sensor cable into the protruding guide (1) on the left-
hand side of the bumper cover.
Applies to the XC70
Cut away approx. 10 mm on the outer corners of the rear
section and foam to make space for the sensors.
21
D8601213
Only applies to the V70
Position the bumper so that sensors can be painted. Ensure that
backing paper covers the area around the sensor holes.
Paint the sensors and holders using the same colour code paint
as the car. Use paint recommended by Volvo. Apply a maximum
of two coats.
When the paint has dried, remove the backing paper.
Note!
Take care to ensure that the activator has dried, at least ten
minutes, before painting.
Caution!
Too many layers of paint may result in partial or complete
malfunction.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Parking assistance, rear- 30664779 - V1.3
Page 14 / 19
