Volvo Penta IPS, Руководство пользователя

Страница: 92 / 140

Fuel System
Only use the grades of fuel recommended in the fuel
specification, see
Fuel System . Always observe the
greatest cleanliness during re-fuelling and work on the
fuel system.
All work on the unit injectors of the engine must be
carried out by an authorized workshop.
WARNING!
Fire hazard. When carrying out work on the fuel system
make sure the engine is cold. A fuel spill onto a hot
surface or an electrical component can cause a fire.
Store fuel soaked rags so that they can not cause fire.
Engine Fuel Filter Replacement
1 Close the fuel tap(s).
2 Place a collection vessel underneath the filter drip
tray to avoid oil spillage.
Clean the filter holder.
3 Undo the coupling piece from the connector ( 1 ) if
fitted with one
4 Relieve the pressure inside the filter by opening the
drain tap ( 2 ) at the bottom of the water separator, if
fitted with one.
5 Unscrew the filter. Use a filter tool if necessary.
6 Screw off the water separator ( 3 ), from the filter.
7 Clean the sealing surfaces on the filter holder.
Make sure that the filter is clean and that the sealing
rings are undamaged.
Moisten the sealing rings with engine oil, including
the rubber sea
IMPROTANT!
Do not fill the new filter with fuel before installation.
Dirt may get into the system and cause damage and
malfunctions.
8 Screw on the new filter by hand until the gasket just
bottoms on the sealing surface. Then tighten a fur-
ther 1/2 turn. Install the water separator and con-
nect the coupling piece. Close the drain tap.
9 Open the main fuel tap.
10 Pump up fuel with the handpump ( 4 ).
11 Start the engine and check that there are no leaks.
Maintenance
90 47705796 05-2014 © AB VOLVO PENTA