In the figure, “X” shown in “3” position, indicates there is open circuit. Note: Because network
cable is made of pair cores, if there is open circuit, it will show faults in pairs, just as above "4"
&" 5". it means either "4" pin or "5" pin exists an open circuit, or both "4" and "5" exist an open
circuit.
Test result 5: open circuit (Remote testing with Remote unit)
In the figure, “X” shown in “4” and “5” pin position, indicates there is open circuit in “4” and “5”
pin of the remote pin. Note: (NF-8601W) Because network cable is twisted pair cables, if there
is open circuit, it will show faults in pairs, just as above "4" &" 5". it means either "4" pin or "5"
pin exists an open circuit, or both "4" and "5" exist an open circuit.
Test result 6: Cross (out of order )
When the cables have cross situation , it will show you
as below :
Test result 7: Short , Open , Cross
If the cable exsits short , open and cross together, will
show you this result : ( 1 and 2 is short , 4 and 5 open , 7 and 8 was cross ):
Test result 8: Continuity test for CAT6
It's the same result with Network cable test ,it will
show as below:
Test result 9: Continuity test for 6 pin telephone cable
The 6-core telephone cable should
insert into the RJ11 interface and the test method and show result is the similar with network
cable.
1 2 X 4 5 6 7 8 G
M:
S:
1 2 X 4 5 6 7 8 G
Open mapping: 3
Test mode:Local
CAT5
Mapping
1 2 3 X X 6 7 8 G
M:
R:
1 2 3 X X 6 7 8 G
CAT5
Mapping
Open mapping: 45
Test mode: Remote
1 2 3 4 5 6 7 8 G
M:
R:
1 2 3 4 5 6 7 8 G
CAT5
Mapping
Test mode: Remote
Cross mapping: 78
X X 3 X X 6 7 8 G
M:
R:
X X 3 X X 6 7 8 G
CAT5
Mapping
Test mode: Remote
Short mapping: 12
Cross mapping: 78
Open mapping:45
Data
upload
Start
Testing
...
CAT6 Mapping
CAT6 Mapping
BNC
Mapping
RJ11
CAT5
CAT6
Mapping
Port Flash
POE
Scan
Menu
Length
Ping
Содержание S-NET1
Страница 1: ...Networks Cable Tester Networks Cable Tester...
Страница 20: ......