a.Cable line-to-line test ( eg: Network cable):
Turn on the device, connect one end of the network cable to “RJ45 Main”, the other end to
“RJ45” port of remote unit. Choose “Mapping” on the main menu, then enter “Cat5” or “Cat6”
to start testing, the testing result will display on the screen directly. If needed, users can also
store the data into TF card.
Test result 1: No connection or the cable doesn't connect well
If the cable doesn't connect
to the main tester, or not connect well, the screen will display as below:
At this time, press to return to the main menu, and then press “ENTER” key for re-test.
Test result 2: Short circuit
: If there is short circuit with the cable and terminal, it will show as
below: (Short circuit at pin 1 & pin 2)
At this time, press to return to the main menu, and then press “ENTER” key for re-test.
Test result 3: correct connection
: If to test a shielded lan cable with remote identifier, and
the cable is good connection, the result is as below graph
R
= Short for “Remote idenfifier”
M
= Short for “Main tester”
G
= Short for “Ground”,the shield layer for STP cable
S
= Short for “RJ45 Scan”
If you press it means back to the last menu and press OK means test again or back to
the main menu for re-test.
Test result 4: open circuit (Local testing with Main tester)
When local test and meet open
circuit, it will show as below:
Data
upload
Start
Testing
.. .
Mapping
RJ11
BNC
CAT5
CAT6
CAT5
Mapping
CAT5
Mapping
Mapping
Port Flash
POE
Scan
Menu
Length
Ping
Cable
open
or
too
short
!
CAT5
Mapping
x x 3 4 5 6 7 8 G
M:
R:
X
X
3 4 5 6 7 8 G
Wire
Map
:
CAT5
Mapping
Short mapping: 12
1 2 3 4 5 6 7 8 G
M:
R:
1 2 3 4 5 6 7 8 G
CAT5
Mapping
Test mode: Remote
OK !
Содержание S-NET1
Страница 1: ...Networks Cable Tester Networks Cable Tester...
Страница 20: ......