d. Cable scanning (POE router & other brand router) NF-8601A doesn’t)
After entering main menu, choose icon”scan” and press OK to enter, then press Up/ Down
button to switch scan modes. Choose “ scanning” mode if scan cable on ordinary switch(graph
No.2), choose “scanning PoE switch” if scan cable on PoE switch (graph No.3).
Caution: users must choose POE switch mode if trace network cables on PoE Switch.
Usage of Receiver
this button on the receiver , when you open the device, and
lighting , that means works normally , Press button “SET” to change the working mode:
scanning cable/ voltage detecing. In scan mode, the scan indicator will be lighten, when you
scan cable, you can take the receiver get close to the tested cables , when it finds the target
cable , it will generate “Beep” , and at the same time , the “scan” indicator will flash when in
voltage detecting mode, NCV indicator will be lighten Take receiver to get closed to the socket
where exsits voltage ,when it will generate sound, which means AC voltage presence.
button on the receiver used to control lighting and detect currency ; button is
sensitivity control when you find the cables. The receiver charge : when connected the
receiver charge , The light will shining near the MICRO , and the same time , the charge
Indicator light will flashing , after full of power , this light will always lit.
1. Tracing cable (RJ45/RJ11 Cable) which is connected to switch or router
. Insert the
cable into port RJ11/ RJ45 (S), turn on the receiver, the led “ power” will be lit, then press
“SET” button, the led "scan" is lit., then hold the receiver close to the cables, when the probe
gets close to the targeted one, you can hear clear and loud “beep,beep, beep” .
(Note: telephone cable into RJ11, Lan cable into port RJ45 Scan)
Note: in this case, users should alter the voice to degree 1~2 in order to find out targeted
cable precisely.
2. Tracing Coax cable
Insert the cable into port BNC, turn on the receiver, the led “ power”
will be lit, then press “SET” button, the led “scan” is lit ., then hold the receiver close to the
cables, when the probe gets close to the targeted one, you can hear clear and loud
“beep,beep, beep” .
Mapping
Port Flash
POE
Scan
Menu
Length
Ping
Scan
Scanning
. . .
Scan
Scanning
.. .
--POE switch--
Содержание S-NET1
Страница 1: ...Networks Cable Tester Networks Cable Tester...
Страница 20: ......