Voltech AT360, Руководство пользователя

Страница: 106 / 470

G
ETTING
S
TARTED
P
AGE
2-72 V
OLTECH
AT
I
U
SER
M
ANUAL
Note
After making the necessary adjustments, you must press ‘Re-Run’ to enable
the component to be recorded as a ‘Pass’.
If further adjustment is necessary, you may re-run from the start as many times
as you like. Unless the option ‘Send Retry Results to Server’ is enabled, there
will be no data sent back to the Server until the measurements for all tests in
the program have been completed.
All transformers are capable of generating voltages much
higher than the test voltage.
When making adjustments, take care not to touch any
transformer terminals, the transformer body, or any
exposed metal on the test fixture. Ideally, make sure that
you use a trimming tool with a well-insulated handle.
When applying a test signal to a winding, always be mindful
of the turns ratio of the transformer that you are testing.
Very high voltages can be generated on the other windings
of the transformer; if these voltages exceed 250V the tester
may be permanently damaged.
!