37
The battery type and current overall voltage
appear on the display. The word “Balancing”
flashes as well.
Press “OK” again to display the voltage values
for the individual cells. The upper line shows
cells 1-3 from the left to the right, the lower line
cells 4-6.
If all cells have the same voltage, the display
indicates “Balance END” and the Power Analyzer
emits 20 signal sound sequences.
Press OK to switch back to the previous display
or ESC to leave the balancer voltage display and
switch to the operating mode menu.
Error Messages during Balancing
If the voltage in one cell drops below the thresh-
old value set in the device, the display says
“CELL LOW VOL” and the Power Analyzer emits
acoustic warnings.
If the voltage of a cell is above the threshold
value set on the device, the DISPLAY says
“CELL HIGH VOL”.
If a cable break or bad contact is present at the
battery’s balancer plug the display says “CELL
CONNECT”.
LiPo Check
LiPo Balance
LiPo-3S
12.457V
Balancing
4.14
0.00
4.16
0.00
4.15
0.00
LiPo-3S
12.421V
Balance END
Figure 11
LiPo-2S
9.310V
LiPo-3S
13.270V
LiPo-3S
8.520V
CELL LOW VOL
CELL HIGH VOL
CELL CONNECT
Figure 12
